Fitters
comments on this installation: "no need to remove rear bumper as access is
good, there are rubber bungs in the floor to take the sensor wires, the CPU fits
inside the nearside rear wing where you will find the wires for the reversing
lights (green with brown stripe).
The display wire runs down the nearside, across the front footwell under the
dash, under the heater in the middle and up through the dash."
Please note that these photo's are of customers' vehicles and should be used for informational purposes only, the installation instructions supplied with the Parking Sensor kit should be adhered to at all times.
Please Note that Parking Sensor systems are designed to be a drivers aid and should not replace the need to drive carefully, we will not accept liability for damage or loss resulting from improper installation or use of this product, infringement of the vehicle manufacturer’s warranty or injury or loss resulting from any accidents however caused.
![Visa Delta [1258 bytes]](http://parking-sensor.co.uk/photos/VISD.gif){kind=small}
